This section explains how to change the bend extremities.
Click the Parameters icon .
The Sheet Metal Parameters dialog box is displayed.
The second tab concerns the bend extremities.
A combo box displays the six possible axial relimitations for the straight bend:
Minimum with no relief: the
bend corresponds to the
common area of the
supporting walls along the
bend axis.
Square relief: a square relief
is added to the bend
extremity. The L1 and L2
parameters can be modified
if need be.
Round relief: a round relief
is added to the bend
extremity. The L1 and L2
parameters can be modified
if need be.
Linear: the unfolded bend is
split by two planes going
through the corresponding
limit points (obtained by
projection of the bend axis
onto the edges of the
supporting walls).
Tangent: the edges of the
bend are tangent to the
edges of the supporting
walls.
Maximum: the bend is
calculated between the
furthest opposite edges of
the supporting walls.